Open source documentation and design files
Open source documentation and design files
This expansion card was developed by IQD to fit inside the White Rabbit Network Switch V4. It will enable the Switch to maintain holdover meeting the following criterion
Move to holdover in <±5µs upon ±2ns Phase error detection of White Rabbit Clock
Here are the links to the open source material associated with this project:
IQD developed the first expansion card to fit the White Rabbit Network Switch V4. As such there are many design decisions and restrictions which needed addressing for the first time.
Here we offer a cut down base card design intended as a first building block for any others attempting to design and build an expansion card to fit this switch
These document contain the following:
Expansion card base starting block:
Production Test System
This PTS board consists of the Production Test System designed to connect the Holdover Expansion board to measurement equipment and enables the confirmation of the function of the Holdover Expansion board.
For more information, click here:
The card interfaces with the switch via the expansion slot located on the rear of the WR Network switch v4. Power is taken from the switch, and no external interfaces are needed to run the card.
For more information, click here:
This project gives the basic requirements of an expansion card needed to fit the WR Network Switch v4. The details are given to assist a new project which would like to interface to the WR Network Switch v4.
For more information, click here:
If you're keen to learn more about the White Rabbit Collaboration or the Switch v4 project, use our Contact Us form.
